PSI Tennessee CMC-C-Mechanical-HVAC/Refrigeration Contractor Book Package

The following books are included in this package and are allowed in the examination center:

International Mechanical Code, 2012

Manual J - Residential Load Calcs, reprinted 2016, Eighth Full Edition

International Fuel Gas Code, 2012

Pipefitters Handbook

Modern Refrigeration and Air Conditioning, 21st Edition

An air duct sizing calculator wheel, slide or similar device

HVAC Duct Construction Standards, Metal and Flexible, 4th Edition 2020

Ugly's Electrical References, George V. Hart, 2011, 2014, or 2020

Carrier System Design Manual Part 3

Code of Federal Regulations - 29 CFR Part 1926 (OSHA

Candidates are responsible for bringing their own references to the examination center. Reference materials may be highlighted, underlined, and/or indexed prior to the examination session. However, references may not be written in. Any candidate caught writing in the references during the examination will be reported to the Board. Furthermore, candidates are not permitted to bring in any additional papers (loose or attached) with their approved references. References may be tabbed/indexed with permanent tabs only. Temporary tabs, such as Post-It notes, are not allowed and must be removed from the reference before the exam will begin. Scratch paper will be provided for calculations. Candidates will NOT be permitted to remove from the examination room ANY material that has been written on. (This would include books).